Low Cadence Intervals in Cycling: How to Do Big-Gear Strength Work
Low cadence intervals in cycling: big-gear climbing at 40-50 rpm for muscular strength endurance. How to do them, where they fit, and the knee cautions.
Low cadence intervals are one of the oldest and most misunderstood sessions in cycling. A big gear, a slow turn of the pedals, a steady climb — nothing flashy. Done in the version that the studies tested, they can be a useful variant of hard interval work. Done in the classic version, they may do less than tradition promises. They are worth understanding properly before you add them to your week.
What low cadence intervals actually are
Low cadence intervals — sometimes called strength endurance work or simply big-gear work — are repeated efforts on a climb at a low cadence — traditionally 40 to 50 rpm, though the studies that found a benefit used 60 to 70, so around 60 rpm is the figure to work with — pushing a hard gear. Worth knowing up front: the classic "moderate heart rate" version is precisely the one with the least evidence behind it. At low cadence you feel the effort in the legs more than in the lungs, because each stroke demands more force. But do not confuse the sensation with the result: in the study closest to classic SFR, twelve weeks of 40 rpm work increased neither leg strength nor performance.
The gradient is a practical choice: a steady, not-too-steep climb — roughly 4 to 7 percent — lets you stay seated, keep cadence controlled, and apply force smoothly across the whole pedal stroke. At gradients around 8 percent pedalling efficiency drops and you would be forced out of the saddle. The word to keep in mind is control: low cadence, yes, but always fluid and round, never jerky or snatched.
What they are actually for
What do low cadence intervals really do? Honesty is needed here: research has found no solid evidence that they improve strength or muscular endurance. The two qualities tradition credits them with:
- Muscular endurance: the idea is that they teach your legs to produce force over sustained periods without fading early. The study closest to the classic version saw no such change.
- Pedalling force: the idea is that they improve your ability to transmit torque — to "drive the gear". The studies that saw a benefit (in uphill power and VO2max) used 60 to 70 rpm at high intensity, and the gain was not in measured strength. If strength is the goal, heavy gym strength training has far stronger evidence — and improves the pedal stroke too.
A myth to let go of: low cadence intervals do not "clean up" the pedal stroke. No study has found a more efficient stroke after weeks of low-cadence work, and actively pulling the pedal up makes pedalling less efficient, not more.
An honest caveat: low cadence intervals are not a shortcut to a higher FTP on their own, and they do not replace threshold or VO2max work. Do not think of them as mandatory foundations either: in the studies where they worked they were simply a variant of hard intervals, not a preparatory phase. If you are not yet clear on what FTP is or how to measure it, start there: how to calculate your cycling FTP is the reference point everything else revolves around.
How to do a session, step by step
A typical structure, to adapt to your level rather than copy blindly:
- A thorough warm-up: at least 20 to 30 minutes building progressively, with a few short accelerations, so you reach the intervals with ready legs, as before any hard work.
- The intervals: to begin, 3 to 4 repetitions of 3 to 5 minutes each, on the climb, staying seated. If you want the version that showed a benefit, keep the intensity high — around threshold — and the cadence around 60 rpm, not lower.
- Recovery: between efforts, roll back down or spin easily on the flat at normal cadence and low intensity, for at least as long as the interval itself. The recovery matters — do not compress it.
- Cool-down: 10 to 15 minutes easy at high cadence to flush the legs out.
With experience you can progress gradually — towards 5 to 6 reps of 5 to 6 minutes, the format used in the studies — but the increase must be slow and steady. One rule for beginners outweighs any spreadsheet: force is applied progressively and under control, without violent snatches from low speed. It is not an absolute ban — low-cadence sprints exist as advanced work — but it is the right progression for those who have never done them.
Where they fit in a training plan
Where to place them is a coaching choice more than a scientific one: tradition puts them in the base period and the early part of the build phase, but one of the positive studies used them in the middle of the racing season.
In the studies they were done twice a week for 4 to 12 weeks. In practice, two low cadence sessions a week for a few weeks is more than enough. As your event approaches and the plan shifts toward threshold, race pace and more specific work, these sessions can taper off or disappear. They should never be stacked alongside other heavy sessions without adequate recovery.
The cautions that genuinely matter
This part needs to be clear, because low cadence intervals are high-force work and deserve the same care as any other.
- Knee health: the caution is right, the classic explanation is not. In biomechanical studies knee load rises with power and with a saddle set too low, not with cadence: at the same watts, pedalling at 40 or 90 rpm does not change the measured forces. No study links low cadence intervals to knee injury. It remains true that, if you have pain or tendinopathy, any high-force work should be assessed with a professional and with a correct bike fit.
- Build gradually: start with a few short reps and increase over time, as with any new high-force work.
- Don't sprint, at first: no explosive launches, no snatched accelerations until you have the experience. Force is applied smoothly and progressively.
- Get your bike fit right: a poor position, under heavy load, magnifies every problem. Make sure your fit is sound before you lean into this work.
- Listen to the signals: any joint discomfort during or after a session is a stop sign, not something to "push through".
Where Per Pro fits in
Sessions like these show clearly why the how and the when matter more than the exercise itself. That is precisely what Per Pro does: it takes the training methodology of real World Tour coaches and rewrites it around your real life — how many of these sessions, at which point in your season, with what cautions given your history and your goals. Not an exercise copied off a chart, but a session placed at the right moment and dosed to your level. You can see how it works at per-pro.com.
Key takeaways
- Low cadence intervals are repeated climbing efforts in a hard gear at around 60 rpm (traditionally 40 to 50, but the studies that found a benefit used 60 to 70 at high intensity).
- The evidence that they build strength, muscular endurance or a cleaner pedal stroke is weak; heavy gym work has far stronger support.
- Starter format: 3 to 4 reps of 3 to 5 minutes, seated, around threshold, with recovery at least equal to the effort.
- Where they sit in the season is a coaching choice; twice a week for a few weeks is plenty.
- Knees: load rises with power and a low saddle, not with cadence. If you have knee pain, get any high-force work checked. Build gradually.
References
The claims in this article rest on the following peer-reviewed publications:
- Hansen EA, Rønnestad BR (2017). Effects of cycling training at imposed low cadences: a systematic review. Int J Sports Physiol Perform, 12(9):1127-1136. doi:10.1123/ijspp.2016-0574
- Kristoffersen M, Gundersen H, Leirdal S, Iversen VV (2014). Low cadence interval training at moderate intensity does not improve cycling performance in highly trained veteran cyclists. Front Physiol, 5:34. doi:10.3389/fphys.2014.00034
- Nimmerichter A, Eston R, Bachl N, Williams C (2012). Effects of low and high cadence interval training on power output in flat and uphill cycling time-trials. Eur J Appl Physiol, 112(1):69-78. doi:10.1007/s00421-011-1957-5
- Paton CD, Hopkins WG, Cook C (2009). Effects of low- vs. high-cadence interval training on cycling performance. J Strength Cond Res, 23(6):1758-1763. doi:10.1519/JSC.0b013e3181b3f1d3
- Lucía A, San Juan AF, Montilla M, Cañete S, Santalla A, Earnest C, Pérez M (2004). In professional road cyclists, low pedaling cadences are less efficient. Med Sci Sports Exerc, 36(6):1048-1054. doi:10.1249/01.MSS.0000128249.10305.8A
- Arkesteijn M, Jobson SA, Hopker J, Passfield L (2013). Effect of gradient on cycling gross efficiency and technique. Med Sci Sports Exerc, 45(5):920-926. doi:10.1249/MSS.0b013e31827d1bdb
- Korff T, Romer LM, Mayhew I, Martin JC (2007). Effect of pedaling technique on mechanical effectiveness and efficiency in cyclists. Med Sci Sports Exerc, 39(6):991-995. doi:10.1249/mss.0b013e318043a235
- Ericson MO, Nisell R (1986). Tibiofemoral joint forces during ergometer cycling. Am J Sports Med, 14(4):285-290. doi:10.1177/036354658601400407
- Ericson MO, Nisell R (1987). Patellofemoral joint forces during ergometric cycling. Phys Ther, 67(9):1365-1369. doi:10.1093/ptj/67.9.1365
- Bini R, Hume PA, Croft JL (2011). Effects of bicycle saddle height on knee injury risk and cycling performance. Sports Med, 41(6):463-476. doi:10.2165/11588740-000000000-00000
- Rønnestad BR, Mujika I (2014). Optimizing strength training for running and cycling endurance performance: a review. Scand J Med Sci Sports, 24(4):603-612. doi:10.1111/sms.12104
- Rønnestad BR, Hansen J, Hollan I, Ellefsen S (2015). Strength training improves performance and pedaling characteristics in elite cyclists. Scand J Med Sci Sports, 25(1):e89-e98. doi:10.1111/sms.12257